login
    
User name
    
Password
  
HomeRate PlansAvailabilityFeaturesSupportSign Up
Support Center  

Installation of Router & Phone Adapter - HT502 Series Devices
DSL/PPPoE Set Up

Follow the steps below to setup the Router & Phone Adapter for your DSL/PPPoE Internet connection.

BEFORE YOU BEGIN : These steps are only needed if your DSL connection requires a User Login and Password entry in order to connect to your DSL service. If so, you must have both your User Login and Password in order to complete these steps. For additional information regarding your User Login and Password, please contact your DSL service provider prior to beginning these steps.
 
NOTE: The easiest way is to start is by connecting a PC directly to your DSL modem and logging into the world wide web as you would normally do. The Phone Adapter will allow you to share your Internet network for both BroadVoice service and your PC. You can connect the BroadVoice adapter and move your PC to the PC port of the Adapter after the first few steps below (see Figure 2 for multiple computer installation with a router/hub).

  1. Prior to installing your Phone Adapter, connect your PC directly to your DSL modem and log into the world wide web as you would normally do. You will connect your PC to the Adapter only after your PPPoE network connection information is entered into your BroadVoice Portal.

  2. Setup your network according to the Figure1 below. Be sure to connect your PC via an Ethernet cable to the LAN/Ethernet port of the Router & Phone Adapter.

    Figure 1: Using a single computer




  3. In an address bar of an open Internet browser type 172.16.0.1 and click the GO button or hit Enter on your keyboard.

  4. Enter end user password of '123'

  5. Select Basic Settings from menu:

  6. Select radio button for use PPPoE.

  7. In the empty field to the right of "PPoE Account ID" enter your DSL login I.D. provided to you by your DSL provider.

  8. In the empty field to the right of "PPPoE Password" enter your DSL password provided to you by your DSL provider.

  9. Click the Update button at the bottom of the screen.

  10. The page will change to the following message and then return after approximately 5 seconds:
    "Your Configuration changes have been saved. They will take effect on the next reboot."

  11. Click the Reboot button.

  12. The green light on the front of the device will blink for up to one minute. Wait until blinking stops.

  13. Talk on the phone and surf the web! Your Phone Adapter is now configured to provide your PPPoE Login information to access your DSL Internet service.

  14. Please return to the BroadVoice installations instructions or Figure 2 below if you are utilizing a router, hub or switch to complete your network setup. As a reminder, the router, hub or switch connects to the PC port of the Phone Adapter. The Adapter is a DHCP server/router and will provide IP addresses for use with a network switch.


    Figure 2: Using a router, hub or switch